Link Search Menu Expand Document

Seeker Pre-Flight Setup

Table of contents

  1. Install Propellers
  2. Safety Check

WARNING: For Safety Disconnect the battery before installing the props

Install Propellers

Install the propellers following the orientation shown. Screw the nuts in by hand, then use an 8mm wrench to tighten them. Make sure to hold onto the motors, and not the props while tightening.

seeker-props.png

The propellors are designed to turn inwards when facing the drone. When the propellors are facing you, the blades should slope downwards towards you. If your props have lettering on them, make sure it faces up. Make sure your props are orientated like below.

WARNING: Make Sure the Props are on Correctly!

seeker-props-3.png

Safety Check

Before flying, make sure to conduct a thorough safety check:

  • Make sure all connectors and cabling is secure and that they are not loose
  • Make sure none of the wires are cut, frayed, or damaged
  • If you have an LTE version, make sure the antennas are secure and are not loose
  • Make sure the SD and SIM cards have not popped out
  • Make sure the reciever is properly plugged in
  • Make sure the cameras are free of any grease, dust, or debris
  • Make sure the battery you are using is properly charged
  • Make sure the props are on correctly and that they are securly attached

Next Step: First Flight